Automatic Boring Head  GWZA-18 with Morse 4 Taper Shank
  • Automatic Boring Head  GWZA-18 with Morse 4 Taper Shank
  • Automatic Boring Head  GWZA-18 with Morse 4 Taper Shank
  • Automatic Boring Head  GWZA-18 with Morse 4 Taper Shank
  • Automatic Boring Head  GWZA-18 with Morse 4 Taper Shank

Automatic Boring Head GWZA-18 with Morse 4 Taper Shank

PLN3,321.00 tax incl.

2700 tax excl.

Boring bar shank diameter: 18 mm;

Boring diameter: 5 - 250 mm;

Taper shank: Morse 4

Quantity

Out of stock

Properties and application:

Boring and facing head is a device that, thanks to multi-position tool mounting and automatic feed, allows you to perform several different machining operations such as:

  • boring in a wide range of diameters
  • turning the front and rear transverse face of the hole and outside turning
  • grooving
  • turning internal and external surfaces by summing up the spindle feed with an automatic feed of the head
  • thread cutting
  • multi-tool boring etc.

Specifications:

Automatic Boring Head GWZA

ParameterValueUnit
Boring diameter 5 - 250 mm
Boring bar shank diameter 18 mm
Offset ± 15 mm
Scale division 0,005 mm/side
0,01 mm/rev
Manual feed per revolution 3 mm
Automatic feed per revolution 0,02; 0,04; 0,06 mm
Dimensions 84 x 58 x 80 mm

 

Read more about Morse taper shank

 

Possible operations:

Operations

GLO_GWZA_MS4

Data sheet

Shank size
Morse 4

Related products

(3 other products in the same category)